Product Description
This is an upgraded driveshaft compared to your factory aluminum shaft
Factory Aluminum shafts are extremely thin wall aluminum (.083" wall thickness) and are not built for any strength or horsepower
This will be built out of thick, quality aluminum (.125" wall thickness) and balanced at a high RPM prior to leaving
This shaft includes a new transfer case yoke and new installed ujoints
If you would prefer a cheaper, factory style shaft, please visit our other listing here:
https://www.alldrivelines.com/1999-2005-silverado-alum-4-15746002-pt/
PART # OFF YOUR ORIGINAL DRIVE SHAFT
# 15746002-JC2
#1571960-GB6
#15751438
#923418-1607M
#921194-6129
#922437-6129
#15165400
This is a brand new aluminum shaft that comes ready to install*Please be advised that these shafts come factory both 4" diameter aluminum and 5" diameter aluminum. This will replace either shaft
Fits 1999-2005 Silverado/ Sierra 1500 4X4 Models - 143-1/2" wheel base
Extended Cab - short bed models
PLEASE CONFIRM MEASUREMENTS OF DRIVE SHAFT OR PART NUMBER OFF YOUR OLD SHAFT MATCHES
Length of Shaft is 68" Center of U-joint to center of U-joint
4" Diameter Tubing
Slip Yoke Specs
- Spline Dia: 1.375
- No Of Teeth: 31/32
- Centerline To End: 7.720"
- Hub Dia: 1.886 (SEAL SIZE)
- Series: 1330 - (1.062" CAP - 3.625" OUTSIDE LOCKUP)
Inside clip on rear end - 3R
Product Videos
Custom Field
Product Reviews
3 Reviews Hide Reviews Show Reviews
-
Super Strong
Really nice drive shaft :) Would definitely recommend . Heavier weight then stock Chevy . Stoked !
-
1999 2005 4 in driveshaft 15746002
Fit great . Easy installation. No more high speed vibration
-
15746002
great value &fit, well balanced had vibration @ 70 mph, is gone now with this driveline install would buy again if needed.