2003-2018 DODGE ALUMINUM CONVERSION DRIVE SHAFT
This is a very large Ujoint series that comes factory on 2014 and newer Dodge Ram applications. The drive shaft is heavy duty, with billet tube yokes. These can withstand quite a bit of power, and have been rated up to 1500 H/P and torque.
If you want the best of the best for your truck, THIS IS IT!
Please CONFIRM before ordering your shaft's measurements from the SEAL of the transfer case to the flat face of the flange at the differential (see picture). Measuring off the truck this way allows the measurement to be more exact and take any lifts or changes to the drivetrain into account.
**PLEASE NOTE, YOU DO NOT NEED THE DRIVESHAFT INSTALLED IN THE VEHICLE TO MEASURE THIS WAY. IT WILL NOT MATTER WHETHER IT IS INSTALLED OR NOT, AS THIS MEASUREMENT IS OVERALL BASED ON THE TRUCK AND DOES NOT INVOLVE DRIVESHAFT
- Heavy Duty 5" .125 wall Alco Aluminum Tubing
- Upgraded 1550 High Quality U-Joints
- New Flange Yoke Installed
- Billet Tube Yokes
- New Slip Yoke installed
- Fully Balanced
- Ready to install
This is NOT a original thin wall aluminum drive shaft- This is a custom made High Quality Drive shaft built to handle torque and power
**Please be advised anything over 86" S-F is subject to an oversize charge of $80 strictly for shipping
If you have any questions, please call! 661-633-2303