Product Description
1973-1987 C-10 Shortbed Aluminum Driveshaft
This is a 1 Piece Alum Driveshaft Only!
Seal to Center Measurement Cannot Exceed 62-3/4"
(We can build a custom driveshaft longer or a 2 piece. Please call to place the order. 661-633-2303)
- 700R4 27 Spline: MUST PROVIDE S-C
- 4L60E 27 Spline: MUST PROVIDE S-C
- Short-Tail T-350 27 Spline: MUST PROVIDE S-C
- Long-Tail T-350 27 Spline: MUST PROVIDE S-C
- 4L80E 32 Spline: MUST PROVIDE S-C
- T-56 31 Spline: MUST PROVIDE S-C
If you have a different transmission than we listed specifications for, we can still build you a shaft! Please provide us the seal to center measurement above
These measurements are from the Seal of the transmission, to the flat face of the differential yoke, or "A" (see picture for reference).
Factory C-10 rear ends will have a 1310 series u-joint. If you have a different rear end than stock, you will need to measure the pinion yoke (see picture for reference).
**Please note: It is the customer's responsibility for ensuring the measurements are correct. If you do not specify a length, we will build the shaft to stock specs listed above. Please confirm your measurement prior to ordering
