Product Description
THIS IS A 2 PIECE CUSTOM MADE HIGH HORSEPOWER DRIVE SHAFT
MUST GET ALL SPECS NEEDED TO BUILD A DRIVE SHAFT
THIS DRIVE SHAFT HAS A STEEL #1 AND AN ALUMINUM #2 SHAFT
FRONT PART OF DRIVE SHAFT IS STEEL 3".083 D.O.M. TUBING
REAR PART OF DRIVE SHAFT IS 5".125 WALL ALUMINUM TUBING, BE SURE TO CHECK YOU HAVE CLEARANCE FOR THE 5" DIAMETER
**RATED FOR UP TO 750 HORSEPOWER AT THE FLYWHEEL**
WE CANNOT BUILD 1310 SERIES 5" ALUM, OPTION COULD BE TO UPGRADE PINION YOKE TO 1350
SELECT TRANSMISSION
SELECT REAR U-JOINT SIZE
WE WILL NEED MEASUREMENTS FROM YOUR VEHICLE
TRANSMISSION SEAL TO CENTER OF CARRIER BEARING
THEN
CENTER OF CARRIER BEARING TO TIP OF PINION YOKE
(IF YOU HAVE A BOLT ON TRANSMISSION YOKE AND/OR A FLANGE AT DIFFERENTIAL WE WILL REQUIRE DIFFERENT MEASUREMENTS AND CAN SEND A FORM IF NEEDED)
**PLEASE BE AWARE SHIPPING INSURANCE VALUE CAPS AT $750.00**
CURRENT PRODUCTION TIME IS: 8 TO 15 DAYS BUSINESS DAYS
**IF THIS IS A TIME SENSITIVE ORDER PLEASE EMAIL FIRST**
AFTER ORDER IS PLACED WE MIGHT CONTACT YOU TO GET MORE INFORMATION TO BUILD THE DRIVE SHAFT
